Art Fair Insiders

Call for Artists, Making Money at Juried Art Fairs, Craft Shows and Festivals

I want to add an extra layer of wind-proofing to my set up when the wind is bad and am looking for some cross-straps, whatever they're called so I can X them on two sides of the tent. I have a Trimline, stabars, plenty of weight, can't think of much else to add other than the straps to keep the tent from popping into my pottery shelves.

I want white straps. Not sure how everyone is attaching them, how long they should be (tent is 9 feet usually) and where the best place to find them might be. I'm over on Amazon looking right now.

Also open to any other suggestions.

Thanks! (I have been wandering through all the other posts on here, didn't see anything specific on the straps...maybe because for most it's common sense and you just popped down to Home Depot or Lowes :-) )

Views: 216

Reply to This

Replies to This Discussion

They are easy to find but I doubt you will find them in white.

How long do they need to be? I found these on Amazon, 12 ft: https://www.amazon.com/SGT-12-Foot-1-Inch-Buckle-Lashing/dp/B00EJSZ...

p.s. I'm not even sure they're the right kind.

Those lashing straps need to connect one end to the other. Wrong type. What you need are ratchet straps that allow you to fasten one end to the tent at the top of the leg and the other end at the opposite legs bottom and then crank to apply tension. You will need a total of 6 (or 8 if you plan to fasten them on the tent entrance at night when you leave)

This is one option of many that are available  

Thank you! I've had my tent go down/trashed and I've gotten a little skittish since then, always trying to find ways to stop the wind-freak-out. Looking for some rubber furniture pads also. After that I need to give it a break and just know I've done the best I can...

how do you attach them... and still close the tent? I have a trimline as well... 12ft work well.... and they must be ratchet , that part i do know... lol

I saw on one picture that they looped the end around and hooked it to the strap. I'm looking at an option now where you build your own...and can choose the ends. I'm thinking maybe a D ring at the end, then I can secure them with zip ties or with a large carabiner onto the top poles / corners. http://www.strapworks.com/ProductDetails.asp?ProductCode=RS1N

Just found these, little bit cheaper than the other custom made ones I just shared: https://www.ratchetstraps.com/tent-straps

here they have load capablities listed... some are only for so many pds... (dont forget to take that into consideration.

Thanks, will do.

RSS

Want to sell more online? Advertise with Sweaterbabe.com. Reach over 60,000 fiber arts lovers.

60 Page Report - Best US Art Fairs

Click Here to
Learn More

Photos

  • Add Photos
  • View All

Top 10 Reviewers on ArtShowReviews.com for January and February

© 2019   Created by Connie Mettler.   Powered by

Badges  |  Report an Issue  |  Terms of Service