Inexpensive Banners for Your Booth

Replies to This Discussion

Permalink Reply by Mark Rogers on August 20, 2010 at 11:49am

I am not aware of a way to get kinks out of clearbags. You have to be very careful shipping them since folding them over can cause a crease. I don’t think a hair dryer would do anything. I just did a test with a heat gun used for shrinking down shrink film and you actually can shrink a clearbag but it takes a lot of heat and the creases are still visible although the surface gets a little smoother.

As far as hanging goes I would recommend the same style that is recommended when hanging prints. Two points at the top edge spaced to split the top edge into equal thirds.

Mark Rogers
Frame Destination, Inc.

• ▶ Reply

Permalink Reply by Mark Rogers on September 2, 2010 at 10:58am

I checked the 20x30 print in a clearbag today that I place on the wall in our warehouse receiving room nearly two weeks ago. The receiving area has a dock door to the outside that is opened a few times every day to bring in freight and has no air conditioning. It has been well over 100 degrees in that room. The waves or large wrinkles that were in the bag when I first hung it are in different locations and might be a little worse but when you look at the image from an angle that does not cause glare on the surface of the bag you can still see the image clearly.

Cheers,
Mark
http://www.facebook.com/FrameDestination
http://www.framedestination.com/

• ▶ Reply

• ‹ Previous
• 1
• 2
• Next ›
• Page